What We Do With Java ... And Others!

Wednesday, January 17, 2007

Savings Bond Interest Calulator

IPF Firewall and FTPD passive mode (Settings) on ipfilter

IPFIREWALL And FTPD PASSIVE MODE (SET)

There are two types of ftp server,
ACTIVE FTP client server

control port 21 <--------- cualquier puerto > 1024 port 20 (data port) --------> any port> 1024

The configuration IPFIREWALL for this type of FTP server would be: # ftp

21 pass in quick from 200.87.105.195/32 to
port = 21 keep state # ftp
data pass in quick from and Stock
to port = 20 keep state

PASSIVE FTP client server

control port 21 1024 <--------- cualquier puerto > ANY port
> 1024 (data port) 1024
<--------- cualquier puerto > IPFIREWALL
The configuration for this type of FTP server would be:

# ftp 21
pass in quick from 200.87.105.195/32 to
port = 21 keep state # ftp

data pass in quick from any to 15001 port 15500 keep state <>

The instruction "keep state" is to tell the filter that you can create a new connection if it had previously created a connection with the customer.

Tuesday, January 16, 2007

Will I Go On My Due Date With Ivf Pregnancy

Activation solaris 10 file

ipfilter 4.0.2
Instructions to enable the packet filter on solaris 10

ipfilter and comes bundled with the Solaris distribution 10, so it's a matter of setup and use.
particularly recommend to use "webmin" for these configuration tasks, as it facilitates these tasks greatly.
1. It must determine the interface on which to act ipfilter, for this use the following instructions:

# ifconfig-a lo0

: flags = 2001000849 mtu 8232 index 1 inet 127.0.0.1 netmask FF000000 nge0:
flags = 1000843 mtu 1500 index 2 inet fffffff8 netmask xxx.xxx.xxx.xxx broadcast xxx.xxx.xxx.xxx ether 0: aa: aa: aa: aa: aa
"As lo0 is the loopback, we take the network card as nge0 by So attached is the file / etc / ipf / pfil.ap, which is as follows: (all who are with # are disability)

# IP Filter setup pfil autopush

# # See the autopush(1M) manpage for more information.
#
# Format of the entries in this file is:
#

#major minor lastminor modules #iprb -1 0 pfil#elxl -1 0 pfil

#e1000g -1 0 pfil
#bge -1 0 pfil
#nf -1 0 pfil
#fa -1 0 pfil
#ci -1 0 pfil
#el -1 0 pfil
#ipdptp -1 0 pfil
#lane -1 0 pfil
# dnet -1 0 pfil
# pcelx -1 0 pfil
# SPWR -1 0 -1 0 pfil pfilnge
nge -1 0 pfil
3.Se must restart the system.
# reebot

4.For test filtering, edit the file / etc / ipf / ipf.conf and place:

block in all block out all
-These instructions block all traffic input and output.
5. To enable the filter to use:

# ipf-E
# ipf-Fa-f / etc / ipf / ipf.conf

6.For disable filtering of the above rules, you must create a file "ipf.not", empty, and run:

# ipf-Fa-f / etc / ipf / ipf.not ****** **** END

I hope this contribution will be helpful ...